Activation Of The Rear Pto Shaft - Dependent Revolutions - Common Working Mode - Zetor Proxima CL 80 Operator's Manual

Activation of the rear PTO shaft - dependent revolutions - common working mode

Number and sense of revolutions depends on the shifted gear and position of the reversing lever. In the
mode dependent revolutions, there is no influence of the position of the reduction lever on the number of
revolutions of the rear PTO.
When the tractor is not going with its engine running:
The operator must sit on the driver's seat.
A - When the clutch pedal is pressed, move the gear shift lever of dependent and independent revolutions to
the lower position (b) to shift dependent revolutions of the rear PTO shaft.
B - When the clutch pedal is pressed, use the gear shift lever to select suitable speed of the rear PTO shaft.
C - When the clutch pedal is pushed down, use the main gear shift to shift a gear and the reversion level to
select the driving direction. In the reduction lever is not in the neutral position, when the tractor starts driving,
the rear PTO shaft starts to rotate as well.
Use the clutch pedal for short-term interruption of torque transmission from the rear PTO
shaft.
If the operator leaves the driver's seat and the
reversing lever or the gear shift lever for crawling
speeds (according to the tractor equipment) is not in
the neutral position (n), an uninterrupted acoustic
signal will be generated.
If the operator leaves the driver's seat and the
reversing lever or the gear shift lever for crawling
speeds (according to the tractor equipment) is in the
neutral position (n), an uninterrupted acoustic signal
will be generated and the engine will be shut down.
PTO DRIVE OF AGRICULTURAL MACHINES
PGPPN175
P18N024
105