Operation; Starting The Engine; Non-Permitted Starting - Zetor Proxima CL 80 Operator's Manual

Before a drive with the new tractor get to know how to shift gears and try individual positions
of the shifting lever when the engine is stopped.
During normal operation and before you set up, make sure that the technical condition ensures safe
operation of the tractor.

Starting the engine

After connecting the battery using the battery disconnecting switch, wait at least 30 seconds
before turning on the ignition key.
1 - The operator must sit on the driver's seat when starting the engine.
2 - Brake the tractor with the hand brake.
3 - Insert the key in the switch box - position '0'.
4 - Push down the clutch pedal.
5 - Move the reversing lever to the neutral position.
6 - If the tractor is equipped with the reversal system, move the gear shift lever to the neutral position.
- If the tractor is equipped with the reductor of crawling speeds, move the lever of crawling speeds to the
neutral position.
7 - Move the lever for activation of the PTO shaft drive to the neutral position.
8 - Make sure that the buttons for activation of the front and rear PTO shafts are not activated (must not be
highlighted).
9 - Switch the key of the switch box from the position '0' to the position 'I'. The glowing signal lamp will be
activated.
10 - Wait until the glowing signal lamp goes out (the time depends on the temperature of the cooling liquid).
In case that the glowing signal lamp only starts flashing instead of glowing, there is a failure in
the glowing system (chapter Indication of glowing system failures). The indicated failure should be
removed in a specialized service centre.
11 - Immediately after the lamp goes out (5 s max.) turn the key from 'I' position to 'II' position (start); the
maximum starting time is 15 s.
12 - After starting the engine, immediately release the key and it is automatically returned to the position 'I'.

Non-permitted starting

It is forbidden to start the tractor by short-
circuiting the starter clamps. Start only from the
driver´s seat. It is necessary to disconnect minus pole
of accumulator and all the shifting levers including
PTO shaft shifting lever to be shifted in neutral
position with any manipulation or repair of the starter.
The starter´s clams are covered with a cap.

OPERATION

P18N081
pikt_2
71