Position Transmitter And Potentiometer Diagnostic; Diagnostic Position Transmitter Rwg - AUMA AC 01.2 Manual

Diagnostics
14.4.

Position transmitter and potentiometer diagnostic

14.5.

Diagnostic Position transmitter RWG

120
Signal state at input:
- DIN 4: Not active (triangle not filled in)
Low level = 0 V = No operation command in direction OPEN
- DIN 5: Active (triangle is black)
Low level = 0 V = EMERGENCY operation command is available
Diagnostic of digital outputs
For the digital outputs (DOUT), both coding and signal states are indicated at the
output by means of symbols.
Table 19: Symbol explanation
Symbol Code
High active
High active
Low active
Low active
Figure 56: Example of DOUT 1 and DOUT 2
Configuration:
- DOUT 1: Indication: Fault has occurred.
- DOUT 2: Indication: End position CLOSED reached
Coding:
- DOUT 1: Low active (Triangle pointing in downward direction)
- DOUT 2: High active (Triangle pointing in upward direction)
Signal state at output:
- DOUT 1: Not active (triangle not filled in)
High level = +24 V DC = no indication (no fault available)
- DOUT 2: Active (triangle is black)
High level = +24 V DC= indication (end position CLOSED reached)
Menu is only visible if the actuator is equipped with a potentiometer.
Required user level: Observer (1) or higher.
Diagnostics M0022
Position transm. potent. M0831
The following states can be checked via diagnostic:
Parameters Menu ID
Low limit Uspan M0832
Volt.level diff. potent. M0833
Raw val. pos. OPEN M0999
Raw val. pos. CLOSED M1001
Potent. raw value /mV M1005
Menu is only visible if the actuator is equipped with electronic position transmitter
(RWG).
Required user level: Observer (1) or higher.
Signal (indication) State output (output contact)
Not active Low = 0 (output contact not operated)
Active High = 1 (output contact operated)
Not active High = 1 (output contact operated)
Active Low = 0 (output contact not operated)
Signification
Low limit Uspan
Volt.level diff. potent.
Raw val. pos. OPEN
Raw val. pos. CLOSED
Potent. raw value /mV
Actuator controls
AC 01.2/ACExC 01.2 Profinet