AUMA AC 01.2 Manual page 94

Failure functions
Information
94
If the Bluetooth interface is in the status "BT_CONNECTED", a change of parameter
value does not cause a status change. In order to change the status, the master
must interrupt the connection or the connection must be interrupted otherwise:
Table 12: Status change for disconnect or abort
Current parameter Current status
value
0 (switched off) BT_CONNECTED
0 (switched off) BT_CONNECTED
1 (switched on) BT_CONNECTED
1 (switched on) BT_CONNECTED
2 (fieldbus or I/O) BT_CONNECTED
2 (fieldbus or I/O) BT_CONNECTED
3 (selector switch posi- BT_CONNECTED
tion OFF)
3 (selector switch posi- BT_CONNECTED
tion OFF)
Timeout for Bluetooth activation
The time during during which the Bluetooth interface remains in status "BT_READY"
after activating via "selector switch position OFF" or after the connection abort by
the Bluetooth master, can be set via a parameter .
Device configuration M0053
Bluetooth interface M2235
M2234
The last menu only exists for configuration via local controls. For AUMA CDT and
AUMA Assistant App, the parameter is already available for configuration in the
Bluetooth interface menu.
Default value: 180 [s]
Setting range: [60 ... 300] [s]
Actuator controls
AC 01.2/ACExC 01.2 Profinet
Cause New status
Disconnect by master BT_OFF
Abort by DCS BT_OFF
Disconnect by master BT_READY
Abort by DCS BT_CONNECTED
Disconnect by master BT_READY (until
timeout)
Abort by DCS BT_OFF
Disconnect by master BT_READY (until
timeout)
Abort by DCS BT_OFF