AUMA AC 01.2 Manual page 149

Actuator controls
AC 01.2/ACExC 01.2 Profinet
Signal
MPV: CCW Position 16
MPV DriveCW
MPV DriveCCW
Input DIN 1
Input DIN 2
Input DIN 3
Input DIN 4
Enable Local
Enable OPEN
Enable CLOSE
PID internal setpoint 2
Remote2_active
Remote2_OPEN
Remote_2_CLOSE
Remote2_STOP
Execute PVST
Bypass Sync In
LPV Sync In
LPV end position CL
LPV sel.sw.Remote
LPV system ok
PID setpoint I/O
PID act. value I/O
RelOPENandCLOSE
Description
Approach position 16 counterclockwise
Clockwise actuator operation
Counterclockwise actuator operation
Signal for controlling output contact
Signal for controlling output contact
Signal for controlling output contact
Signal for controlling output contact
Enables the selector switch function (LOCAL/OFF) on the local controls
Interlock: Enables operation command in direction OPEN
Interlock: Enables operation command in direction CLOSE
Internal PID setpoint
Activation of operation mode Remote II
Operation command OPEN in operation mode Remote II
Operation command CLOSE in operation mode Remote II
Operation command STOP in operation mode Remote II
PVST is executed
Enable signal for <By-pass function>
Enable signal for LPV function (synchronisation)
LPV slave actuator has reached end position CLOSED
Selector switch of LPV slave actuator is in position REMOTE
LPV slave actuator is ready for operation
Change-over of process controller setpoint source between fieldbus interface and I/O interface
Change-over of process controller actual value source between fieldbus interface and I/O interface
Enable signal OPEN/CLOSE
Appendix
149