Bhss Trim Installation - Assa Abloy Corbin Russwin ML2000 Series Installation Instructions Manual

BHSS Trim
ML2000 Series Mortise Lock
Installation Instructions
3

BHSS Trim Installation

1. Install strike using 3/4" strike mounting screws.
NOTE:
STRIKE MUST BE ORIENTED WITH
NARROWER HOLE ON LOWER HALF OF
STRIKE AND STRIKE LIP TOWARDS PULL
BHSS Strike
SIDE OF DOOR . (FIGURE 15)
Installation
2. CYLINDER FUNCTIONS ONLY:
Slide cylinder(s) through spring and collar,
threading into lockbody until cylinder face is
flush with collar. (Figure 16)
NOTE:
Cylinder
PULL KEY SLIGHTLY OUT OF CYLINDER TO HELP
Installation
THREAD INTO LOCKBODY .
NOTE:
CYLINDER MUST BE ORIENTED CORRECTLY .
(FIGURE 17)
3. CYLINDER FUNCTIONS ONLY:
Install cylinder set screw(s). (Figure 18)
4. Fully tighten lock mounting screws.
For installation assistance contact Corbin Russwin
1-888-607-5703 • support@corbinrusswin.com
Copyright © 2017 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
NOTE: Key and
cylinder must be
rotated as shown
®
ASSA ABLOY
Correct Incorrect
Figure 17
Wider Hole
Narrower Hole
Cylinder
Set Screw
5
Strike Lip
Figure 15
Figure 16
Figure 18
FM352 10/18