Blss Trim Installation - Assa Abloy Corbin Russwin ML2000 Series Installation Instructions Manual

BLSS Trim
ML2000 Series
Installation Instructions
5

BLSS Trim Installation

1. Install strike using 3/4" strike mounting screws.
Note:
Strike must be oriented with narrower hole on
lower half of strike and strike lip towards pull
side of door. (Figure 15)
2. Cylinder functions only:
Slide cylinder(s) through spring and collar,
threading into lockbody until cylinder face
is flush with collar. (Figure 16)
Note:
Pull key slightly out of cylinder to help thread
into lockbody.
Note:
Cylinder must be oriented correctly. (Figure 17)
3. Cylinder functions only:
Tighten cylinder set screw. (Figure 18)
4. Fully tighten lock mounting screws.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Note:
Key and cylinder must
be rotated as shown
Correct Incorrect
Figure 17
Strike Lip
Wider Hole
Narrower Hole
Figure 15
Cylinder
Set Screw
Figure 18
6
Figure 16
FM351 08/19