Table of Contents
Advertisement
Grade 1 Key-In-Lever VR Lever Lock
CL3100 Series
Installation Instructions
14
Installation: CL3100 Lever Lock with High Security Lever (cont.)
d
Remove Cylinder
1. Remove security screw on outside of lever with 6 lobe wrench.
2. Insert key and rotate key 45° clockwise; keep key in this position.
3. Using screwdriver, tighten the security attachment screw clockwise
until it clears the lever.
4. Remove lever and remove key.
5. Remove cylinder from lever and install new cylinder.
6. Reinstall lever following steps on previous page.
15
Dummy Trim Installation
CL3150/70 Half/Full Dummy Trim C, E and K Rose
1. Align mounting plate on both sides of the door with the five (5) holes prepared in the door.
Note
The dimple faces the door edge.
2. Install screw from the opposite side of the door.
Note
Be sure to install mounting plate aligning clearance hole and threaded hole.
2A. Install washer and screw from the opposite side of the door
(half dummy).
3. Install four (4) surface screws (#4 flat head Phillips screws)
in the mounting plate.
4. Align and place the rose on both sides of the door.
5. Place and tighten rosette with CL3100 wrench.
6. Install lever.
7. Tighten 6 lobe security set screws.
PLEASE REFERENCE
TEMPLATE: T31194
For Installation Assistance contact Corbin Russwin
1-888-607-5703 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2016, 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
clearence
Clearance
hole
hole
1
3
5
4. Rose
4 rose
5 rosette
5. Rosette
7
6
7
3
Figure 23
Cylinder Removal
5. Rosette
rosette 5
4. Rose
rose 4
3
Full
Dummy
Trim
2
1
threaded hole
Threaded hole
re v erse of flange
reverse of flange
Dimple
dimple
Figure 24
Dummy Trim Installation C, E and K
13
6 lobe security
6 lobe security
wrench
wrench
1
45°
4
2
6
7
7
5
2A
Half
Dummy
Trim
FM345 01/19
Advertisement
Table of Contents
