Assa Abloy Corbin Russwin ML2000 Series Installation Instructions Manual page 7

BHSS Trim
ML2000 Series Mortise Lock
Installation Instructions
3 BHSS Trim Installation
10. Slide inside adapter plate over spindle and
install using two adapter plate mounting
screws. (Figure 23)
NOTE:
MAKE SURE ADAPTER PLATE TAB AND SET
Mount Escutcheon
SCREW HOLE ARE FACING LOCK FRONT PRIOR
TO INSTALLING SCREWS .
11. With lever in "up" position, install inside trim
assembly.
NOTE:
AFTER TRIM IS INSTALLED, ROTATE LEVER TO
Inside Trim
MAKE SURE SPINDLE IS ENGAGED IN LOCK .
Assembly
Installation
12. Tighten inside lever set screw. (Figure 24)
13. Install three escutcheon mounting screws
through inside escutcheon. (Figure 24)
14. Install lock front using two front screws.
(Figure 25)
Lock Front
Installation
For installation assistance contact Corbin Russwin
1-888-607-5703 • support@corbinrusswin.com
Copyright © 2017 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
Adapter
Plate Tab
Set Screw
Hole
Inside Lever
Set Screw
Figure 24
7
Figure 23
Inside Trim
Mounting
Screws
Figure 25
FM352 10/18