Assa Abloy Corbin Russwin ML2000 Series Installation Instructions Manual page 6

BHSS Trim
ML2000 Series Mortise Lock
Installation Instructions
3 BHSS Trim Installation
5. Thread adapter plate hub into lever and fully
tighten. (Figure 19)
NOTE:
SPINDLE CAN BE USED TO HELP THREAD HUB
INTO LEVER .
Spindle & Outside
Trim Assembly
Installation
6. Align adapter plate hub with square hole in lever;
keeping hub as tight as possible. (Figure 20)
Adapter Plate
Installation
7. Insert spindle into outside trim assembly.
8. With lever in "up" position, align mounting posts
on adapter plate with holes in lockbody and
install outside trim assembly. (Figure 21)
NOTE:
AFTER OUTSIDE TRIM IS INSTALLED, ROTATE
LEVER TO MAKE SURE SPINDLE IS ENGAGED IN
LOCK .
9. Insert spindle into lockbody on inside of door.
(Figure 22)
For installation assistance contact Corbin Russwin
1-888-607-5703 • support@corbinrusswin.com
Copyright © 2017 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
6
Outside Trim
Adaptor
Plate
Hub
Figure 19
Figure 20
Outside Trim
Mounting
Posts
Figure 21
Use Correct Spindle Orientation
BAD GOOD
Figure 22
FM352 10/18