Bhl Trim Installation - Assa Abloy Sargent 8200 Installation Instructions Manual

BHL Trim
8200 Mortise Lock
Installation Instructions
4

BHL Trim Installation

1. Install strike using 3/4" strike mounting screws.
NOTE:
STRIKE MUST BE ORIENTED WITH STRIKE LIP
TOWARDS PULL SIDE OF DOOR . (FIGURE 10)
2. CYLINDER FUNCTIONS ONLY:
Slide cylinder(s) through spring, spacer and
collar, threading into lockbody until cylinder
face is flush with collar. (Figure 11)
NOTE:
PULL KEY SLIGHTLY OUT OF CYLINDER TO HELP
THREAD INTO LOCKBODY .
NOTE:
CYLINDER MUST BE ORIENTED CORRECTLY .
(FIGURE 12)
3. CYLINDER FUNCTIONS ONLY:
Tighten cylinder set screw. (Figure 13)
4. Fully tighten lock mounting screws.
5. Insert spindle adapter into lockbody on outside
trim. (Figure 14)
NOTE:
SPINDLE ADAPTER ONLY GOES ON OUTSIDE
TRIM .
1-800-727-5477 • www.sargentlock.com
Copyright © 2017, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the express
written permission of Sargent Manufacturing Company is prohibited.
NOTE: Key and
cylinder must be
rotated as shown
Correct Incorrect
Figure 12
Figure 14
6
Figure 10
Figure 11
Figure 13
A8131E 11/17