Advertisement
Push/Pull (HPSK) Paddle Trim
ML2000 Series Mortise Lock
Installation Instructions
3
HPSK Trim Installation
1. Install strike using 3/4" strike mounting screws.
NOTE:
STRIKE MUST BE ORIENTED WITH
NARROWER HOLE ON LOWER HALF OF
STRIKE AND STRIKE LIP TOWARDS PULL
SIDE OF DOOR . (FIGURE 14)
2. CYLINDER FUNCTIONS ONLY:
Slide cylinder(s) through spring and collar,
threading into lockbody until cylinder face is
flush with collar. (Figure 15)
NOTE:
PULL KEY SLIGHTLY OUT OF CYLINDER TO HELP
THREAD INTO LOCKBODY .
NOTE:
CYLINDER MUST BE ORIENTED CORRECTLY .
(FIGURE 16)
3. CYLINDER FUNCTIONS ONLY:
Install cylinder set screw(s). (Figure 17)
4. Fully tighten lock mounting screws.
5. Align cam and chassis as shown based on
desired paddle orientation. (Figure 18)
Vertical Paddle
For installation assistance contact Corbin Russwin
1-888-607-5703 • support@corbinrusswin.com
Copyright © 2017 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
Mounting Post Location
=
CAM
Mounting Post Location
Paddle DOWN
Wider Hole
Narrower Hole
NOTE: Key and
cylinder must be
rotated as shown
®
ASSA ABLOY
Correct
Incorrect
Figure 16
OR
Vertical
Vertical
Paddle UP
5
Strike Lip
Figure 14
Figure 15
Cylinder
Set Screw
Figure 17
Mounting Post
Location
CAM
=
Horizontal Paddle
Figure 18
FM339 10/18
Advertisement
