Adjusting Customer-Focused Drying Modes; Removing The Front Panel/Drum Assembly; Reinstalling The Front Panel/Drum Assembly - Kenmore Oasis 110.67032600 Manual

ADJUSTING CUSTOMER-FOCUSED
DRYING MODES
NOTE: If the customer is complaining about
the clothes being damp and the moisture sen-
sor passes TEST #5, step 3, the total dry time
for an automatic cycle can be lengthened by
changing from a "1" (standard auto cycle) to a
"2" (15% more drying time) or "3" (20% more
drying time) auto cycle.
1. Press and hold the Dryness Level button
for 5 seconds. The dryer will beep and
display CF for one second, then the cur-
rent drying mode will be seen on the dis-
play. The factory default value is "1".
2. To select a different drying mode, press
the Dryness Level button again. The dry-
er display will flash and show the avail-
able settings.
3. With the display flashing the selected
drying mode, press the Start button to
save the drying mode and exit (the Start
button in this mode does not start a dry-
ing cycle). The result will be stored in EE-
PROM of the control board, and will be
retained after a power loss.
4. Press the Stop button at any time to can-
cel changes and exit from this mode.
REMOVING THE FRONT
PANEL/DRUM ASSEMBLY
1. Unplug dryer or disconnect power.
2. Open the door.
3. Push on the retaining clips located under
top of dryer on the right and left side us-
ing a flat object such as a putty knife. See
Figure 13.
Front Cover Screw
(Inside Cabinet)
Top Clips
Figure 13. Slowly rotate top backwards
and support.
Door Switch
Connector
4. Slowly rotate top backwards and lean
against wall, or support with a prop rod.
5. Disconnect the door switch wire harness
located on the right side. See Figure 13.
6. Remove the front panel/door assembly
by removing the two front cover screws
at the top of the panel inside the cabinet,
and lifting upward.
7. Disconnect the moisture sensor connec-
tions. See Figure 11.
8. Remove the lint screen.
9. Remove the lint screen housing by re-
moving the four screws holding the lint
screen housing. See Figure 14.
10. Remove the front bulkhead by loosening
the upper two screws and removing the
lower two screws. See Figure 14.
Figure 14. Remove the front bulkhead.
11. Lower components can be accessed at
this time, however, if the drum is to be
removed, the belt must be removed. See
TEST #3a, step 5.
Reinstalling the Front Panel/Drum
Assembly
Refer to preceding removal sections and re-
place in reverse order.
NOTE: Make sure to reconnect the moisture
sensor wire connections.
6-15