Kenmore Oasis 110.67032600 Manual page 92

Figure 6.
Slowly remove drum belt.
5. Remove the white connector from the
drive motor switch. See Figure 7.
Figure 7.
Remove white connector.
Main Winding:
and Bare Copper Wire (1 position)
Start Winding:
Blue Wire in Back
and Bare Copper
Wire (3 position)
Figure 8. Main and start winding
measure points.
6. Using Figure 8, check for the resistance
values of the motor's Main and Start
winding coils as shown in the following
table.
NOTE: Main and Start winding coils must
be checked at the motor.
Tension
Drum
Pulley
Belt
Drive Motor
Switch
White
Connector
Blue Wire in Back
WINDING RESISTANCE
MAIN
START
• If the resistance at the motor is correct,
there is an open circuit between the
motor and machine control electronics.
Check for failed belt switch.
• If the Start winding resistance is much
greater than 4 ohms, replace the mo-
tor.
7. Check the belt switch by measuring re-
sistance between the two blue wires, as
shown in Figure 9, while pushing up the
belt switch pulley.
Belt Switch
Figure 9.
• If the resistance reading goes from in-
finity to a few ohms as pulley arm clos-
es the switch, belt switch is OK. If not,
replace the belt switch.
• If belt switch is OK and there is still an
open circuit, check and repair the wir-
ing harness.
8. Door switch problems can be uncovered
in the Door Switch Diagnostic Test; how-
ever, if this was not done, the following
can be done without applying power to
the dryer. Connect an ohmmeter across
P8-3 (neutral, white wire) and P8-4 (door,
tan wire).
6-24
CONTACT POINTS
Ω OF MEASUREMENT
Blue wire in back at
pin 4 and bare copper
1.4–2.6
wire on pin 5 of black
drive motor switch
Blue wire in back at
pin 4 and bare copper
1.4–2.8
wire on pin 3 of black
drive motor switch
Blue Wires
Tension
(Back and 4 position)
Pulley
Checking the belt switch.