Optional 3-wire connection
Use for direct wire or power supply cord
where local codes do not permit connect-
ing cabinet-ground conductor to neutral
wire.
1.
Remove center silver-colored terminal
block screw.
2.
Remove neutral ground wire from exter-
nal ground conductor screw. Connect
neutral ground wire and the neutral wire
(white or center wire) of power supply
cord/cable under center, silver-colored
terminal block screw. Tighten screw.
A
A. External ground conductor screw
B. Center silver-colored terminal block screw
C. Neutral ground wire
D. Neutral wire (white or center wire)
³⁄
E.
" (1.9 cm) UL listed strain relief
4
F. Grounding path determined by a qualified electrician
3.
Connect the other wires to outer terminal
block screws. Tighten screws.
4.
Tighten strain relief screws.
5.
Insert tab of terminal block cover into slot
of dryer rear panel. Secure cover with
hold-down screw.
6.
Connect a separate copper ground wire
from the external ground conductor screw
to an adequate ground.
7.
You have completed your electrical con-
B
nection. Now go to "Venting Require-
ments."
C
D
E
F
2-12