STARTING THE DRYER
Follow these basic steps to start your dryer.
Please refer to specific sections of this manual
for more detailed information.
1. Clean lint screen before each load.
2. Place laundry into dryer and shut door.
3. Press POWER.
4. Turn the cycle selector knob to the desired
cycle. The preset settings for Auto Dry
Cycles or Timed Cycles will illuminate.
The estimated (Auto Dry Cycles) or actual
(Timed Cycles) cycle time (in minutes) will
show in the display.
NOTE: A default time is displayed when an
Auto Dry Cycle is selected. During the first
few minutes of the drying process, the cycle
time may automatically vary from the default
time based on the size and fabric type of the
load. Toward the end of the drying process,
the estimated time display will adjust again,
showing the final drying time.
TO USE AN AUTO DRY CYCLE
•
Press POWER.
•
Select an Auto Dry Cycle.
•
Select DRYNESS LEVEL to adjust how
dry you want the load. As the cycle runs,
the control senses the dryness of the load
and adjusts the time automatically for the
selected dryness level.
The default dryness setting is Normal when
an Auto Dry Cycle is selected. You can select
a different dryness level, depending on your
load, by pressing DRYNESS LEVEL and
choosing More, Normal or Less. Selecting
More, Normal or Less automatically adjusts
the dryness level at which the dryer will shut
off. Once a dryness level is set, it cannot
be changed without stopping the cycle.
•
Select the desired Options.
To make changes during an Auto Dry
Cycle:
•
Press STOP.
•
Adjust Dryness Level.
NOTE: Dryness Level selections can be
made only while using Auto Dry Cycles.
Auto Dry Cycles take the guesswork out
of drying time and enhance fabric care.
The amount of time that is displayed is the
estimated time remaining in the cycle.
TO USE A TIMED CYCLE
•
Select a Timed Cycle.
•
Press the TIME ADJUST (More Time or Less
Time) buttons until the desired drying time
is displayed. Press MORE TIME or LESS
TIME once and the time will change by
1-minute intervals. Press and hold MORE
TIME or LESS TIME and the time will change
by 5-minute intervals.
NOTE: The Time Adjust feature can be used
only with Timed Cycles.
•
Press TEMPERATURE until the desired
temperature illuminates.
NOTE: During a Timed Cycle, you can change
the settings for Time, Temperature, WRINKLE
GUARD
and Cycle Signal.
®
NOTE: The Temperature feature can be
used only with Timed Cycles.
5. (OPTIONAL STEP) If desired, select OP-
TIONS. For more details, see "Options."
3-2