Kenmore Oasis 110.67032600 Manual page 99

3. Push on the retaining clips located under
top of dryer on the right and left side us-
ing a flat object such as a putty knife. See
Figure 14.
Front Cover Screw
(Inside Cabinet)
Top Clips
Figure 14. Slowly rotate top backwards
and support.
4. Slowly rotate top backwards and lean
against wall, or support with a prop rod.
5. Disconnect the door switch wire harness
located on the right side. See Figure 14.
6. Remove the front panel/door assembly
by removing the two front cover screws
at the top of the panel inside the cabinet,
and lifting upward.
7. Disconnect the moisture sensor connec-
tions. See Figure 12.
8. Remove the lint screen.
Door Switch
Connector
9. Remove the lint screen housing by re-
moving the four screws holding the lint
screen housing. See Figure 15.
10. Remove the front bulkhead by loosing
the upper two screws and removing the
lower two screws. See Figure 15.
Figure 15.
11. Lower components can be accessed at
this time, however, if the drum is to be
removed, the belt must be removed. See
TEST #3a, step 4.
Reinstalling the Front Panel/Drum
Assembly
Refer to preceding removal sections and re-
place in reverse order.
NOTE: Make sure to reconnect the moisture
sensor wire connections.
6-31
Remove the front bulkhead.