Kenmore Oasis 110.67032600 Manual page 43

c) Unlock and pull the edge connector off
the user interface board.
UI Board Connector
d) Remove the cycle selector switch from
the user interface assembly opening
by lifting the locking tab on the cycle
selector switch, and turning the selec-
tor switch in a counterclockwise direc-
tion.
e) Locking tabs located at the bottom of
the console insert panel secure the
user interface assembly to the con-
sole insert panel. Using a flat-blade
screwdriver, gently apply pressure to
the locking tabs to release the user
interface assembly. NOTE: When
replacing the cycle selector switch,
make sure that the shaft is positioned
through the center of the shaft seal
that is captive between the decorative
overlay and the console insert panel.
Cycle Selector Switch
User Interface Board
Locking Tabs
7. To remove the machine control:
a) Disconnect the machine control board
connectors at P4, P2, P13, P8, and P9,
then pull the red and black wires off the
heater relay terminals.
b) Remove the hex-head screw from the
rear of the machine control housing.
P4
P2
P13
c) Push the clip on the back, and slide
the machine control housing to the left
and off the mounting bracket and re-
move the assembly.
Housing Bracket
Machine Control
Continued on the next page.
4-3
Machine Control
Housing Screw
P9
Slide
P8
RD
BK