Id 200/C-Pdp Web Interface; Connection To The Pc; Hardware / Physical Interface; Connection Setup - Bosch Rexroth ID 200/C‑PDP Manual

56/84

ID 200/C-PDP web interface

Bosch Rexroth AG, MIT: ID 200, 3 842 540 399/2016-11
8 ID 200/C-PDP web interface
The communication module has an integrated web server. It has a web interface,
which delivers status information and enables the device to be configured.

8.1 Connection to the PC

The network connection via the serial interface with Windows 7 is only supported
from ID 200/C-PDF firmware version 1.2, code 07.12.12.
8.1.1

Hardware / physical interface

The web server is addressed via a PPP connection (Point-to-Point Protocol) on
the web interface. The PPP connection is used automatically after a PC direct
connection is established.
With the ID 200/C-PDP, the PC direct connection is established via the RS232
diagnosis interface.
8.1.2

Connection setup

In the Windows 7 Control Panel you have to install a special kind of Modem that uses
a serial COM port - and not your probably built-in modem in your PC.
To do this, you need system administrator permission on the Windows 7 PC
In the Control Panel select Phone and Modem
f
If requested, enter the Location Information – only for dummy, because you don't
f
call ID 200 by phone modem.