Bosch B426 Manuals

Table of Contents

• • 2

    Table of Contents

• 4

  IP Communicator Component Overview

• 4

  Table of Contents

• 5

  Bus Type, Address Selection and Function

• 5

  Maintenance and Troubleshooting Leds

• 7

  How to Connect to RPS Using the IP Communicator

  • 7

    How to Connect to RPS Using: 'Connect Via: IP Direct
  • 8

    How to Connect to RPS Using 'Connect Via: Network
    • 8

      B8512G/B9512G or GV4
    • 8

      FPD-7024, All G Series 6.0 and Higher, GV2 and GV3 Types

• 8

  How to Configure the IP Communicator Using Keypad Programming

  • 8

    When Using B920 or B930 SDI2 Type Keypads
  • 9

    When Using D1255 or D1260 SDI Type Keypads
  • 10

    How to Configure the IP Communicator Using Remote Programming Software

• 11

  How to Configure the IP Communicator Using the Web Browser

  • 12

    Basic Network Settings Page
  • 12

    Advanced Network Settings Page
  • 13

    Panel Address Settings Page
  • 13

    Select the Device Address Remotely
  • 14

    Encryption and Security Settings Page
    • 14

      Encryption Enable
    • 14

      Web and Automation Security
  • 15

    Maintenance Page
  • 15

    Factory Default Page
  • 16

    Firmware Upgrade Page

• 17

  Connect to the Web Interface When the IP Address Is Unknown

• 17

  Determine if the B426 Is the Original or the Modified Version

• 17

  Replace an IP Communicator Connected to SDI2 Keeping the Original Settings

• 18

  Troubleshooting

  • 18

    Trouble Connecting the IP Communicator to the Web Interface
    • 18

      Applications with the IP Communicator Set to Dhcp/Auto-Enable=Yes
    • 18

      Applications with the IP Communicator Set to Dhcp/Auto-Enable=No
  • 19

    There Is a Problem with the Security Certificate When Logging Into the Web Interface
  • 19

    The IP Communicator Led's Are Not Working
  • 19

    Can Supervision Be Disabled for the IP Communicator
  • 19

    The IP Communicator Settings in RPS Are Greyed Out or Keypad Programming Is Locked
  • 20

    Trouble Connecting to RPS Using the IP Communicator
    • 20

      Verify Correct Panel Account Type Selected in RPS for Existing Panel Firmware Revision
    • 20

      Verify Correct Module Address Selection
    • 20

      Check for Address Conflicts
    • 21

      Verify the Correct RPS Passcode Is Used When Connecting
    • 22

      Trouble Connecting to RPS: 'Connect Via: IP Direct
    • 23

      Trouble Connecting When Using Connect Via: Network
    • 23

      Verify Correct Encryption Settings (G or Non-G Thru GV4 V1.00-1.99 Types Only)