Process Data Operation; Assignment Of The Process Data Channel; Fig. 5-1: Process Picture In The Input/Output (Memory) Area Of Your Interface Module - Bosch Rextroth Indramat RECO R-IB IL CNT Applications Manual

Counter Terminal
5

Process Data Operation

5.1

Assignment of the Process Data Channel

Input/output
DOK-CONTRL-R-IL*CNT***-AW02-EN-P
The counter terminal is configured, controlled and read via process data.
The process picture of the counter terminal on the BUS ring is comprised
of two data words.
Observe the correct data consistency!
⇒ Make sure there is a data consistency of two words
DANGER
In this regard, observe the instructions in chapter "Tips for Working with
the Counter Terminal" on page 7-9.
Controller board
Output (memory) area
INTERBUS
Fig. 5-1: Process picture in the input/output (memory) area of your interface
module
The data word is in the process data memory area on your interface
module. This memory area represents a process picture of your entire
application, i.e. your bus construction. You assign the addresses via the
physical or logical addressing of the interface module.
The process data (memory) area consists of an output (memory) area
and an input (memory) area. Both memory areas do not necessarily have
to be different.
otherwise the values may be incorrectly interpreted!
Input (memory) area
IB IL CNT
Register
Process data
channel
Process Data Operation
59790008
59790008.eps
5-1