Terminal Setup And Configuration - Westpac EFTPOS Connect User Manual

2.7 Terminal setup and configuration.

To begin setting up your new EFTPOS Connect terminal:
1. Make sure the terminal base is connected to power.
2. Make sure the terminal base is connected to your POS via a supported
communications method.
3. Make sure the terminal is fully charged or is sitting on the terminal base for power.
4. Make sure that your POS software is running on your POS. Please contact your POS
provider or refer to your POS Guide if further information is required.
5. Hold down the green 'ENTER' key found at bottom right corner of the terminal keypad,
until an audible beep is heard and/or the terminal screen powers on.
6. Connect the USB cable on the base to your POS.
7. Follow the instructions for Bluetooth pairing shown on the next page.
Your Terminal screen should display 'Ready', at which point you can begin transacting
via your POS software.
11