Table of Contents
Advertisement
2.3
Powering up
Connecting base station to power
1� Insert the power cable into the power port
on the terminal base�
2� Plug the AC power cord into a wall outlet or a
power surge�
3� Place terminal on charger to begin charging
the terminal�
Manual Start-up
Hold the green (Enter) key down for about 10 seconds until terminal displays the start-up screen�
Manual Shutdown
Hold the red (Cancel) key down for about 10 seconds until the terminal displays the shutdown
verification screen� Keep holding the red key until the terminal shuts down� (Must be unplugged
from power supply before attempting manual shut down)
2.4
Loading paper
1� On top of your terminal, lift and open the black paper compartment latch�
2� Position the paper roll with the end of the roll protruding from underneath the roll towards
the terminal screen�
3� Pull paper out slightly and close the cover�
2.5
Getting started
Your EFTPOS 1i terminal arrives as a complete unit� Included in your delivery is:
• quick reference guide
• terminal
• terminal base
• paper rolls
• power supply
• cables (RS232 serial, USB and dial cables)�
For any PC-EFTPOS software queries, please contact the PC-EFTPOS Help Desk on
02 9998 9800�
4
BANK OF MELBOURNE EFTPOS 1i TERMINAL USER GUIDE
Communication type
The terminal supports PC-EFTPOS IP Gateway via the POS�
In the event that your main communication method is down, the terminal will automatically
failover to 3G/GPRS backup communications�
2.6
Terminal setup and configuration
To begin setting up your new EFTPOS 1i terminal:
1� Ensure the terminal base is connected to power�
2� Ensure the terminal base is connected to your Point of Sale (POS) via a supported
communications method�
3� Ensure the terminal is fully charged, or is sitting on the terminal base for power�
4� Ensure that your POS software is running on your Point of Sale� Please contact your Point of
Sale provider or refer to your POS Guide if further information is required�
5� Hold down the green "Enter" key found at bottom right corner of the terminal keypad, until an
audible beep is heard and/or the terminal screen powers on�
6� Follow the instructions for Bluetooth pairing below�
Your terminal should display "Ready" on-screen, at which point you can begin transacting via
your POS software�
2.7
Terminal pairing with base (Bluetooth)
Your terminal uses Bluetooth communications between the Keypad and the Base, with security
measures in place for all communications�
If the base does not display a solid blue light (indicating that it is currently paired with the
terminal), follow these instructions to pair the terminal with the base:
• Press the button on the front of the base and wait for the blue light to begin blinking�
• On the Keypad, select the correct base by identifying the 9-digit serial number printed on the
underside of the base�
• Wait for the pairing to complete, which will be indicated by a solid blue light displayed on the
base�
The terminal will display the following message if Bluetooth pairing has not occurred or is
unsuccessful:
TERMINAL SCREEN
READY
NOT PAIRED
Common issues in the initial pairing process include power and communications issues which
are often resolved by checking the connections between device and power outlets� Please
contact the Merchant Helpdesk for further assistance�
BANK OF MELBOURNE EFTPOS 1i TERMINAL USER GUIDE
5
Advertisement
Table of Contents
