Removal - Overhead Console; Installation - Chrysler Dodge Caravan 2002 Manual

RS
OVERHEAD CONSOLE (Continued)
down until "VAR = XX" appears in the display. This
takes about five seconds.
(4) Release the push button(s). "VAR =XX " will
remain in the display. "XX" equals the current vari-
ance zone setting.
(5) On Electronic
(EVIC) and Compass Mini-Trip Computer (CMTC)
equipped vehicles momentarily depress and release
the Step push button to step through the zone
numbers, until the zone number for your geographic
location appears in the display. On Compass Temper-
ature Module (CT) equipped vehicles depress the
US/M push button to step through the zone num-
bers, until the zone number for your geographic loca-
tion appears in the display.
(6) On Electronic
(EVIC) and Compass Mini-Trip Computer (CMTC)
equipped vehicles momentarily depress and release
the Reset push button to enter the displayed zone
number into the EVIC/CMTC module memory. On
Compass Temperature Module (CT) equipped vehicles
depress the C/T push button to enter the displayed
zone number into the electronic module memory.
(7) Confirm that the correct directions are now
indicated by the compass.

REMOVAL - OVERHEAD CONSOLE

(1) Disconnect and isolate the remote negative bat-
tery cable.
Fig. 2 Variance Settings
Vehicle Information
Vehicle Information
(2) Remove the overhead console retaining screw,
located in the front of console.
(3) Using your fingertips, grasp the sides of the
overhead console and pull straight down evenly to
disengage the two snap clips at the rear of the unit.
Center (4) Lower the overhead console far enough to
access the wire harness connectors.
(5) Disconnect the EVIC, CMTC or CT electronic
module and the reading/courtesy lamps electrical
connector.
(6) Remove the overhead console from the vehicle.

INSTALLATION

(1) Position the overhead console in the vehicle.
(2) Connect the EVIC, CMTC or CT electronic
Center
module and the reading/courtesy lamps electrical
connector.
(3) Using your fingertips, grasp the sides of the
overhead console and push straight up evenly to
engage the two snap clips at the rear of the unit.
CAUTION: DO NOT PRESS ON THE SUNGLASS
STORAGE BIN DOOR. DAMAGE TO THE DOOR MAY
RESULT.
(4) Install the overhead console retaining screw,
located in the front of console. Torque the screw to
1.2 N·m (10 in. lbs.).
(5) Connect the remote negative battery cable.
MESSAGE SYSTEMS 8M - 5