Removal - Overhead Console; Installation; Special Tools - Chrysler 2004 Concorde Service Manual

LH
OVERHEAD CONSOLE (Continued)
ture can be obtained by enabling the EASY EXIT
SEAT feature and disabling the REMOTE LINKED
TO MEMORY feature. Then the EASY EXIT SEAT
feature will move the seat back, but the RKE unlock
event will not reposition the seat. Thus, the seat
remains positioned for easy entry, and the memory
switch on the door panel can be depressed after
entering the vehicle to return the seat to the desired
memory position.
• SIDE VIEW MIRROR TILT - This programma-
ble feature only applies to vehicles equipped with the
optional memory / heated system. The options
include Enable and Disable. The default is Disable.
When Enable is selected, both side view mirrors will
move straight downward anytime the MHSM module
detects a reverse gear indication from the cluster.
This feature is designed to allow the driver to see
directly behind the rear wheels before backing up.
• TRAIN REMOTE - When this feature is
selected the driver can choose to train up to four
remote keyless entry transmitters. The options
include Yes and No. The default is No. When Yes is
selected and the MENU button is pressed the EVIC
will display "PRESS REMOTE LOCK & UNLOCK
THEN PRESS UNLOCK", followed by a chime to
indicate the training sequence can commence. You
have approximately 30 seconds to train up to four
transmitters, after each transmitter is trained a
chime will sound indicating that the training was
successful. If remote link to memory is "YES" , the
first transmitter trained will be associated with
memory setting 1 and the second transmitter trained
will be associated with memory setting 2. Additional
transmitters will not be associated with a memory
setting. When you have finished training the trans-
mitters, press the menu button again and the EVIC
will display "TRAIN DONE "X" TRAINED. If no
transmitters are trained within approx. 30 seconds
the EVIC will display "TRAIN TIMEOUT".
• RETRAIN TIRE SENSORS - This programma-
ble feature only applies to vehicles equipped with the
optional Tire Pressure Monitoring System. The
options include Yes and No. The default is No. When
Yes is selected, and the menu button is depressed,
the EVIC will enter the training mode starting with
the left front tire.

REMOVAL - OVERHEAD CONSOLE

(1) Disconnect and isolate the remote negative bat-
tery cable.
(2) Remove the overhead console retaining screw,
located in the front of console near the windshield.
(3) Using your fingertips, grasp the sides of the
overhead console and pull straight down evenly to
disengage the two snap clips at the rear of the unit.
(4) Lower the overhead console far enough to
access the wire harness connectors.
(5) Disconnect the control module, courtesy lamps
and if equipped, the power sunroof switch electrical
connectors.
(6) Remove the overhead console assembly from
the vehicle.

INSTALLATION

(1) Position the overhead console in the vehicle
and connect the wire harness connectors.
(2) Connect the control module, courtesy lamps
and if equipped, the power sunroof switch electrical
connector.
(3) Using your fingertips, grasp the sides of the
overhead console and push straight up evenly to
engage the two snap clips at the rear of the unit.
(4) Install the overhead console retaining screw,
located in the front of console near the windshield.
Torque the screw to 1.2 N·m (10 in. lbs.).
(5) Connect the remote negative battery cable.

SPECIAL TOOLS

Degaussing Tool 6029
Radio Frequency Detector #9001
MESSAGE SYSTEMS 8M - 7