Chrysler Dodge Caravan 2002 Manual page 588

RS
POWER MIRRORS (Continued)
SWITCH CONNECTOR
12 Volts
PIN 12
PIN 7
PIN 6
PIN 6
PIN 13
PIN 8
PIN 1
PIN 1
PIN 5
(4) If results shown in table are not obtained,
check for broken or shorted circuit, or replace mirror
assembly as necessary.
AUTOMATIC DAY / NIGHT
MIRROR
DESCRIPTION
An automatic dimming inside day/night rear view
mirror and an automatic dimming driver side outside
rear view mirror are available factory-installed
options on this model. Following is a general descrip-
tion of this optional equipment.
The automatic day/night mirror is able to automat-
ically change its reflectance. A thin layer of electro-
chromic material between two pieces of conductive
Fig. 1 Power Mirror Connector
POWER MIRROR MOTOR TEST
Ground
PIN 6
PIN 6
PIN 12
PIN 7
PIN 1
PIN 1
PIN 13
PIN 8
PIN 11
MIRROR REACTION
Right
—
—
—
—
UP
LEFT
DOWN
RIGHT
LAMP
glass make up the face of the mirror. Two photocell
sensors are used to monitor light levels and adjust
the reflectance of the mirror to reduce the glare of
headlamps approaching the vehicle from the rear.
For removal procedures, (Refer to 23 - BODY/IN-
TERIOR/REAR VIEW MIRROR - REMOVAL).
OPERATION
The ambient photocell sensor faces forward, to
detect the outside light levels. A second sensor faces
rearward to detect the light level received through
the vehicles back window. When the difference
between the two light levels becomes too great (the
light level received at the rear of the mirror is much
higher than that at the front of the mirror), the mir-
ror begins to darken.
POWER MIRRORS
Left
UP
LEFT
DOWN
RIGHT
—
—
—
—
LAMP
8N - 47