Chrysler Dodge Caravan 2002 Manual page 566

RS
POWER SLIDING DOOR SYSTEM (Continued)
CONDITION
Key fob, B-pillar or
overhead console switch
does not power operate
door
Door does not stay open
High inside/outside opening
effort
POSSIBLE CAUSES
Cables worn and stretched
Binding or sticking of components
Blown Fuse
Battery voltage low
Failure of latch assembly
Wiring problems (system or vehicle)
Failure of body control module
Failure of key fob
Failure of sliding door control module
Failure of door motor assembly
Failure of hold open latch assembly
Failure of hold open latch striker
Failure of latch assembly
POWER SLIDING DOOR SYSTEM
CORRECTION
Striker damaged
Replace striker if necessary
Replace cables as necessary
Establish location of binding and replace
necessary components
Check fuse and replace
Charge or replace battery
Check for foreign matter preventing the
operation of latch assembly
Check wire connection
Pawl and/or ratchet switch inoperative
Replace latch if necessary
Troubleshoot using electrical schematics.
Refer to wiring diagrams
Check electrical connections
Refer to the body diagnostic manual for
additional checks
Replace BCM if necessary
Replace key fob battery
Replace key fob if necessary
Disconnect then reconnect battery to reset
module, function door, if no function exists
check for loose wire connections, see Body
Diagnostic Manual for detailed procedures
Check for foreign matter preventing the
operation of gear motor assembly
Check wire connections
Gear motor clutch does not engage,
replace assembly
Full open switch inoperative, replace hold
open latch assembly
Replace motor assembly. if necessary
Check wire/cable connections
Replace hold open latch, if necessary
Replace hold open latch striker, if
necessary
Check wire connections and for blown fuse
Check cable connections
8N - 25