Chrysler Dodge Caravan 2002 Manual page 356

RS
POWERTRAIN CONTROL MODULE (Continued)
(M) Check Engine Lamp (MIL) will illuminate during engine operation if this Diagnostic Trouble Code was recorded.
(G) Generator Lamp Illuminated
GENERIC DRB SCAN TOOL DISPLAY
SCAN TOOL
CODE
P0522
P0523
P0532
P0533
P0551 (M) Power Steering Switch Failure
P0562
P0563
P0579 Speed Control Switch #1 Performance
P0580 Speed Control Switch #1 Low
P0581 Speed Control Switch #1 High
P0582 Speed Control Vacuum Solenoid
P0586 Speed Control Vent Solenoid Circuit
P0594 Speed Control Servo Power Circuit
P0600 (M) PCM Failure SPI Communications
P0601 (M)
P0604
P0605
P0615
P0622 (G) Generator Field Not Switching Properly
P0627
P0630 VIN Not Programmed In PCM
P0632 Odometer Not Programmed In PCM
P0633 SKIM Key Not Programmed In PCM
P0645
Oil Pressure Sens Low
Oil Pressure Sens High
A/C Pressure Sensor Low
A/C Pressure Sensor High
Battery Voltage Low
Battery Voltage High
Circuit
Internal Controller Failure
Internal Trans Controller
Internal Trans Controller
Starter Relay Circuit
Fuel Pump Relay Circuit
A/C Clutch Relay Circuit
ELECTRONIC CONTROL MODULES
DESCRIPTION OF DIAGNOSTIC TROUBLE CODE
Oil pressure sensor input below acceptable voltage.
Oil pressure sensor input above acceptable voltage.
A/C pressure sensor input below the minimum acceptable
A/C pressure sensor input above the maximum acceptable
Incorrect input state detected for the power steering switch
circuit. PL: High pressure seen at high speed.
Battery voltage sense input below the minimum acceptable
Battery voltage sense input above the maximum acceptable
Cruise switch stuck in a valid voltage range.
Speed control switch input below minimum acceptable
Speed control switch input above maximum acceptable
An open or shorted condition detected in speed control
Vacuum solenoid control circuit.
An open or shorted condition detected in speed control vent
solenoid control circuit.
An open or shorted condition open/short condition detected
in the speed control servo power control circuit.
No communication detected between co-processors in the
control module.
Internal control module fault condition (check sum) detected.
Transmission control module RAM self test fault detected.
-Aisin transmission.
Transmission control module ROM self test fault detected
-Asian transmission.
Open or shorted condition detected in the starter relay
control circuit.
An open or shorted condition detected in the generator field
control circuit.
An open or shorted condition detected in the fuel pump relay
control circuit.
VIN is not programmed in the control module EEPROM.
Odometer is not programmed in the control module
SKIM secert key is not programmed in the control module
An open or shorted condition detected in the A/C clutch relay
control circuit.
voltage.
voltage.
voltage.
voltage.
voltage.
voltage.
EEPROM.
EEPROM.
8E - 19