Chrysler Dodge Caravan 2002 Manual page 97

3 - 18 HALF SHAFT - REAR
CV BOOT - INNER/OUTER (Continued)
(6) Remove the snap-ring holding the tripod
assembly onto the interconnecting shaft (Fig. 11).
Fig. 11 Remove Snap-Ring
1 - SNAP RING
2 - HALF SHAFT BOOT
3 - TRIPOD ASSEMBLY
4 - SNAP RING PLIERS
(7) Remove the tripod assembly from the intercon-
necting shaft (Fig. 12).
Fig. 12 Slide Tripod Off The Shaft
1 - TRIPOD ASSEMBLY
2 - AXLE SHAFT
3 - HALF SHAFT BOOT
(8) Remove the CV boot from the interconnecting
shaft (Fig. 13).
Fig. 13 Remove Boot
1 - HALF SHAFT BOOT
INSTALLATION
(1) Clean the interconnecting shaft and inner CV
joint of any residual grease and dirt.
(2) Slide the new small diameter retaining clamp
onto the interconnecting shaft.
(3) Install the CV boot onto the interconnecting
shaft (Fig. 14).
Fig. 14 Install CV Boot Onto Interconnecting Shaft
1 - HALF SHAFT BOOT
RS