Chapter 2 "Indoor" Installation; Before You Begin; Safety; Verifying And Unpacking - American Dynamics SpeedDome Ultra Camera Installation And Service Manual

Before You Begin

Safety

ALWAYS USE:
• Proper safety equipment for the location and
type of installation.
• Proper lift equipment to reach the installation.
• Safety features of the lift equipment.
BE SURE:
• Electrical power is not connected to the dome
during installation.
• Electrical power is not connected to nearby fix-
tures that you might touch during installation.
WARNING!
!
Do not install this product in hazardous
areas where highly combustible or explosive
products are stored or used.

Verifying and Unpacking

• Verify that all parts have arrived and their
configuration is correct.
• Lay out parts in the order you will need them.
Do not clutter the area or create a trip hazard.

Tools and Equipment Required

You should have on hand the following equipment
•
Dome Software (latest version)
•
Phillips-head screwdriver
•
0.4 x 2.5mm slotted screwdriver (for wire
connections)
•
Power drill with 1/8", 1/4", and 3/8" drill bits
•
Hammer
•
Socket wrench with 5-inch extension, and 5.5mm,
7mm, 10mm, and 11mm (7/16") sockets
•
18-14 AWG and 22-20 AWG wire strippers
•
Install/Removal tool to attach and detach domes and
bubbles without a ladder
•
Hand vacuum and broom.

Parts Check

Other than these instructions, in the shipping box
for the dome are the following parts:
•
Base assembly, 0100-1340-01
•
Housing and eyeball assembly, 0100-1036-01
•
Installation kit, 0351-1109-01.
•
Optional slot cover kit, 0351-1163-01

I/O Board Detachment

Before beginning
perform the following procedure to detach the I/O
board from the dome's base.
Procedure
!
Push the fingers away from the board while
pushing on the I/O board with your index finger
(Figure Chapter 2-1). Put the board aside in a
safe place.
:
Figure Chapter 2-1. Detaching the I/O board
SPEEDDOME ULTRA
2-2
INDOOR INSTALLATION
the installation
Dust cover. The I/O board has a dust
cover. DO NOT remove this cover until you
have installed the dome's base. It protects
the delicate spring finger connector.
Keep the dust cover for use should you
have to ship the mounting base back to the
manufacturer.
CAUTION—ELECTROSTATIC SENSITIVE
DEVICE! Use a grounding strap when
handling the board.
a
procedure,