Install And Detect The Illustra 625 Ptz Dome; Installation Using Dhcp And Illustra Connect - American Dynamics ADCI625-P221 Configuration And User's Manual

Installation
Install and Detect the Illustra 625 PTZ Camera
The following provides detailed information for installing and accessing the dome.

Installation using DHCP and Illustra Connect

The following provides information for installing the dome on your network using the Illustra
Connect discovery tool.
Illustra Connect enables automatic discovery of compliant devices on IP networks and is the
recommended method for installation and detection of the dome on the network.
Note
The Illustra Connect will only discover devices on the same subnet as it's host computer.
Therefore the dome and the computer being used to configure it must be on the same subnet.
Procedure 2-1 Installing the Illustra 625 PTZ Camera using Illustra Connect
Step Action
Using the Quick Start Guide install and connect the dome to the computer or network
1
which will be used for the configuration and power on.
The dome will begin its initial boot up sequence which will take approximately 1 to 2
minutes.
When using a DHCP Server the dome will automatically be assigned a Network IP
2
address.
Using a computer which is connected to the same network and subnet, install the Illustra
3
Connect software that is provided with the dome. Refer to the Illustra Connect manual for
more information.
When the installation is complete, run Illustra Connect. It will search the network and
4
display all compliant devices, including the dome.
Select the dome you wish to configure, locating it by it's unique MAC address. Illustra
5
Connect allows basic configuration of the dome.
Refer to the Illustra Connect manual for more information.
Right-click the dome and select Launch Web GUI Configuration.
6
Refer to the Web Configuration chapter for details on how to log in to the dome and modify
7
the configuration.
2-6
- End -
Configuration and User Guide