Chapter 3 -System Setup; The Intellex Unit; Starting The Intellex Unit - American Dynamics Intellex Intellex LT Installation And Operating Instructions Manual

14
Chapter 3 —System Setup
STARTING
THE INTELLEX
UNIT

Starting the Intellex Unit

Intellex
CAUTION: Before connecting power, set the voltage switch
to the appropriate voltage ("115" or "230").
To start up the Intellex unit, simply plug it in. If the unit does not
power up, insert the special tool provided (or a paper clip) in the
pinhole beneath the power indicator to turn on unit power.
CAUTION: Do NOT modify any BIOS or system settings. Do
NOT reconfigure any hard drives. Otherwise, you will
affect unit operation.
During the power-up cycle, the Intellex splash screen appears. If
you are powering up the unit for the first time, a message may
appear with the splash screen. Do not press any buttons on the front
panel or any keys on the keyboard until this screen disappears.
Wait at least two minutes for the message and/or the splash screen
to disappear. Otherwise, you may interrupt the startup process and
affect unit operation. If the splash screen does not disappear after
two minutes, see the Intellex Troubleshooting Guide.
CAUTION: Do NOT install any other software, including
screen savers, or you will affect unit operation.
When the main screen appears, the unit begins showing live video
from the attached cameras, based on the schedule.
NOTE: Security is disabled at the factory. However, if the unit
displays the login screen, enter the administrator's default
PIN code (1234). See
page 95 for more information.
When installing the unit, configure the unit in the following order:
• Regional settings
• Mouse settings
• Time zone settings
• Network settings (for Network Client only)
• Printer settings
• Language selection (see
®
LT Digital Video Management System
Logging In and Changing Users
Language Setup on page 22)
on