Perimeter Protection - American Dynamics Intellex Intellex LT Installation And Operating Instructions Manual

72

Perimeter Protection

Schedule Setup
Intellex
NOTE: The pointer changes to
location.
c. Click the mouse button to lock this boundary and start a new
one.
d. Repeat these steps until you are ready to enclose the target
area.
e. Use one of the following methods to enclose the target area:
• Set at least three endpoints. Then hold the mouse pointer
over the last endpoint and double-click the button. The
boundary lines disappear and the target area is defined
by a semitransparent grid.
• Move the mouse pointer to the starting point and click
the mouse button. The boundary lines disappear and the
target area is defined by a semitransparent grid.
4. To draw an additional target area, repeat steps 1 through 3.
5. To deactivate some of the targets, select Deactivate. Then
draw a deactivation target area, using steps 1 through 3.
Click Apply to apply the configuration for this filter as shown and
close the Motion Detection screen. Click Cancel to cancel the
changes and return to the previous screen. Click Help to display
online help for this screen.
Use the Perimeter Protection screen to configure the target area for
the perimeter protection filter. Once configured, the filter is
triggered whenever an object crosses into or out of the target area.
After you select the Perimeter Protection filter and click the Setup
button, the Perimeter Protection screen appears.
Perimeter Protection: (camera name) — Indicates the camera
name.
Image Area — This area of the screen displays a camera image and
provides a reference when configuring the filter.
Active Perimeter — Use the following options when configuring
the target area. This area can be nearly any shape or size.
Restore — Click this button to restore the active perimeter to
its dimensions when you first accessed this screen.
®
LT Digital Video Management System
if it is dragged to an invalid