Restart; Exit To System - American Dynamics Intellex Intellex LT Installation And Operating Instructions Manual

Installation and Operating Instructions

Restart

Exit to System

Utility Options
Select one of the following options:
• If unit power is still on, insert a paper clip into the pinhole
above the REC indicator to reset the unit.
• If unit power is off, insert a paper clip into the pinhole below
the power indicator to power up the unit.
CAUTION: Do NOT modify any BIOS or system settings. Do
NOT reconfigure any hard drives. Do NOT install any
other software, including screen savers, or you will
affect unit operation.
Use this option to exit from the Intellex system and gain access to
the Windows operating system.
NOTE: Exiting to the system is a protected feature. You must
possess the Exit to System privilege to access it (see
Security Setup
1. From the main screen, click the Utility button. The Utility
Options screen appears (see
2. Click Exit. A confirmation message appears.
3. Select No to cancel the exit process and return to the Utility
Options screen. Click Yes to exit Intellex and go to Windows.
The Enter PIN Code screen appears.
4. Enter the system exit code. (Contact your dealer or
Sensormatic for this code.) The unit displays asterisks as a
security measure.
a. Use the mouse pointer to click the numeric buttons to
enter the code. Click backspace to erase an entry.
b. Click OK to exit Intellex and go to the Windows
operating system.
The system verifies the code. If you entered an incorrect PIN
code, the system returns to normal operation. If you entered the
correct PIN code, the system exits Intellex and goes to
Windows.
on page 39).
Utility Options
109
on page 105).