American Dynamics Intellex Intellex LT Installation And Operating Instructions Manual page 46

32
Cameras Setup
Intellex
• Select TT16E V2.x if you have a VM16 or ADTT16E with
version 2.x firmware.
• Select NONE if this camera cannot be controlled or if you
do not wish to permit remote control of this camera. This
is the default selection.
NOTE: The Version 2.x firmware permits simultaneous local (at
the Touch Tracker) and remote (via Network Client)
control of different cameras through the same Touch
Tracker. The Touch Tracker must have version 2.x
firmware for this mode to work.
4. After you select a camera handler, the Setup button will be
active for that camera. Click Setup to select the camera
address and COM port. You MUST perform the complete
Setup on each controlled camera for proper camera and
Intellex unit operation.
• The default camera address is the Intellex camera number.
Normally this is correct. If the TT16E V2.x camera handler
is used, the SensorNet address of the camera must be
used.
• The MUX port is the COM2 port that is normally used
when the Touch Tracker is used to select cameras on
Intellex. This port must be used if this control is desired.
Any other COM port on the Intellex can be used for
camera control only.
Click OK to accept the changes made. Click Cancel to cancel the
changes. Click Help to display online help for this screen.
Connection between the Intellex unit and the dome requires an
EIM and Touch Tracker. Supported domes include the following:
• SensorNet-connected SpeedDome (Ultra IV, Ultra V, or Ultra
VI when available), and
• Optima (and compatible domes such as Ultra III) with
firmware version 3.05 or later.
Remote control functions include Dome Select, Pan, Tilt, Zoom,
Focus, Iris control and Call Preset.
®
LT Digital Video Management System