Installation and Operating Instructions
INSTALLATION
AND USE OF
INTELLEX
ACCESSORIES
Intellex USB Floppy
Drive-RDVFLP01
If the USB Floppy drivers are
already installed in Intellex
Intellex USB CD-RW
Drive-RDVCDRX01
If the USB CD-RW drivers are
already installed in Intellex
Installation and use of Intellex Accessories
The Intellex USB floppy drive can be used to save Intellex
configurations, single .bmp images from the image tools feature,
and to install software patches and upgrades.
DV8000 and DV16000 units with product codes D80024x-xxx and
D60024x-xxx as well as some earlier DV8000 and DV16000 systems
already have the USB floppy drivers installed.
Installation
Insert the USB cable of the floppy drive into one of the USB
connectors in the rear of the Intellex. It is not necessary to exit
Intellex.
The Intellex USB CD-RW drive can be used to export video clips to
CD-R or CD-RW disks or to update the Intellex software.
NOTE: Do not disconnect the CD-RW while an export is in
progress. The data will be lost and the media will be
ruined.
DV8000 and DV16000 units with product codes D80024x-xxx and
D60024x-xxx already have the USB CD-RW drivers installed.
Installation
The first time that the CD-RW is connected to the Intellex unit, you
must exit the Intellex application software and set the drive
properties in Windows.
1.
Exit Intellex by selecting Utility, Exit.
NOTE: Exiting to the system is a protected feature. You must
possess the Exit to System privilege to access it.
2.
Connect the USB CD-RW to the Intellex unit by connecting
the cable from the CD-RW to the USB connector on the rear of
the unit. Some messages may appear as the device is
recognized and added to the device list.
177