Sealing The Envelope Only, Bypass All Printing; Filling The Moistener Tank; Installing The Ink Cartridge - Pitney Bowes SendPro С User Manual

Sealing the envelope only, bypass all printing

You can seal an envelope without printing postage or anything else on it.
1. On the Home screen, tap Envelope Printing.
2. Tap Print Mode. You may need to swipe up on the screen to see this option.
3. Select Seal Only.
4. Tap Apply.
5. Place your envelope face up, flap down into the feeder. Be sure to slide the envelope flap under
the edge of the feed deck.

Filling the moistener tank

Your device will periodically need refills of E-Z Seal® in order to seal envelopes. Follow these steps to fill
the moistener tank.
1. Check the level of sealing solution in your moistener tank.
2. Add enough to bring the sealant level up to the bottom of the fill hole. Do not overfill your tank.
3. If the tank is empty, allow 30 minutes for the moistener brush and wick to get completely saturated.

Installing the ink cartridge

Your device uses ink from the ink cartridges during normal maintenance cycles. You must maintain
adequate ink supply in all of the cartridges to keep the system in optimal working condition. Replace your
ink cartridges, printhead and other similar printing consumables promptly when warned.
Your device will periodically require a new ink cartridge.
Pitney Bowes User Guide July 2020
1 • Quick start guide
22