Cisco TelePresence ISDN Link Administrator's Manual page 58

Cisco TelePresence ISDN Link
Contents Introduction
ISDN BRI MaxDeactiveTime
Set the maximum duration for Layer 1 in de-active state before auto activation (re)starts.
<1..60>
Value space:
Range: Select a value between 1 and 60 seconds.
ISDN BRI SwitchType
Select the type of BRI switch the system is connected to.
<NI/ATT/Euro/Japan/1TR6/Australia/FETEX>
Value space:
NI: Select NI if the switch is a National ISDN switch type.
ATT: Select Att if the switch is an At&t (for the u.S.) ISDN switch type.
Euro:
Select euro if the switch is an euro (uK and others) ISDN switch type.
Japan: Select Japan if the switch is a Japanese ISDN switch type.
1TR6: Select 1tR6 if the switch is an 1tR6 switch type.
Australia: Select Australia if the switch is an Australian ISDN switch type.
FETEX: Select FeteX if the switch is a FeteX ISDN switch type.
ISDN BRI Interface [1..4] DirectoryNumber [1..2] Number
Configure the Directory Numbers for the various BRI interfaces.
<S: 0, 24>
Value space:
Format: String with a maximum of 24 characters.
ISDN BRI Interface [1..4] Mode
Select BRI interface 1 to 4, and set the BRI interface mode.
<Off/On>
Value space:
Off: Set to off to disable the selected BRI interface.
On: Set to on to enable the selected BRI interface.
D14954.04 ISDN Link Administrator Guide IL1.1.2, MARCH 2015.
Getting started Software upgrade
ISDN BRI Interface [1..4] SPID [1..2] Number
ISDN BRI Interface [1..4] TestLoopmode
ISDN BRI Interface [1..4] TestPattern
ISDN PRI Alert
58
Status information
Configure the SPID Numbers for the various BRI interfaces.
<S: 0, 20>
Value space:
Format: String with a maximum of 20 characters.
Select BRI line test mode. this configuration should only be used in test scenarios. It is not
persistent, and will restore to default setting after a restart. testLoopmode is only effective if
BRI is the active network.
<Off/Line/LineBChan>
Value space:
Off: Normal operation (default).
Line: Loop BRI line back to the network.
LineBChan: Loop BRI B-channels back to the network.
Select whether a test pattern is sent. this configuration should only be used in test scenarios. It
is not persistent, and will restore to default setting after a restart. testPattern is only effective if
BRI is the active network.
<Off/INFO1>
Value space:
Off: Normal operation, no test pattern sent (default).
INFO1: Send INFo1 (00111111) test pattern.
Select if the system should respond with an alert message to all incoming setup messages, or
to the first incoming channel only.
<Off/On>
Value space:
Off: When set to off (default) the system will respond with an alert message only to the
incoming setup message related to the initial channel. Note that if the PBX requires this
signalling you will only get connected on the first incoming channel.
On: When set to on, the system will respond with an alert message to all incoming setup
messages.
Administrator Guide
System settings System settings Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.