Cisco TelePresence ISDN Link Administrator's Manual page 65

Cisco TelePresence ISDN Link
Contents Introduction
Network [1..1] QoS Diffserv Video
the Diffserv Video defines which priority Video packets should have in an IP network. the
higher the number, the higher the priority. these priorities might be overridden when packets
are leaving the network controlled by the local network administrator.
<0..63>
Value space:
Range: Select a value from 0 to 63. A recommended value for Video packets is Diffserv
Code Point (DSCP) AF41, which equals the value 34. If in doubt, contact your network
administrator.
Network [1..1] VLAN Voice Mode
Set the VLAN voice mode.
Note: the ISDN Link and the telePresence endpoint must be configured for the same VLAN.
First configure the ISDN Link, then configure the endpoint. If done opposite, or if configured
to different VLANs, the two devices will lose contact and you will need to connect to the
ISDN Link through the serial interface to complete the VLAN configuration. When set to Auto
on both devices, the CDP provisioner on the network, if present, will take care of the VLAN
configuration.
Note: If configuring the telePresence endpoint for provisioning to CuCM, note that the VLAN
Voice Mode is automatically set to Auto on the endpoint when the Provisioning Mode is set to
CuCM. In cases like this: First set the VLAN Voice Mode to Auto on ISDN Link, then configure
the telePresence endpoint for provisioning to CuCM.
<Auto/Manual/Off>
Value space:
Auto: the Cisco Discovery Protocol (CDP), if available, assigns an id to the voice VLAN. If
CDP is not available, VLAN is not enabled.
Manual: If the ISDN Link is paired with a telePresence endpoint; first set the VLAN Voice
VlanId, then set the VLAN Voice Mode to Manual. the VLAN Voice ID is set manually using
the Network VLAN Voice VlanId setting. If CDP is available, the manually set value will be
overruled by the value assigned by CDP.
Off: VLAN is not enabled.
Network [1..1] VLAN Voice VlanId
Set the VLAN voice ID. this setting will only take effect if VLAN Voice Mode is set to Manual.
<1..4094>
Value space:
Range: Select a value from 1 to 4094.
D14954.04 ISDN Link Administrator Guide IL1.1.2, MARCH 2015.
Getting started Software upgrade
NetworkServices configuration
NetworkServices SSH Mode
NetworkServices NTP Address
NetworkServices NTP Mode
65
Status information
SSH (or Secure Shell) protocol can provide secure encrypted communication between the
codec and your local computer.
<Off/On>
Value space:
Off: If disabling SSH Mode and operating in automatic pairing mode, it will no longer be
possible to manage the ISDN Link via the telePresence endpoint's web interface.
On: the SSH mode is enabled.
enter the NtP Address to define the network time protocol server address. this address will
be used if NtP Mode is set to Manual, or if set to Auto and no address is supplied by a DHCP
server.
<S: 0, 64>
Value space:
Format: String with a maximum of 64 characters.
the Network time Protocol (NtP) is used to synchronize the time of the system to a reference
time server.
<Off/Auto/Manual>
Value space:
Off: the system will not use an NtP server.
Auto: the system will use the NtP server, by which address is supplied from the DHCP
server in the network. If no DHCP server is used, or the DHCP server does not provide
the system with a NtP server address, the system will use the static defined NtP server
address specified by the user.
Manual: the system will always use the static defined NtP server address specified by the
user.
Administrator Guide
System settings System settings Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.