Cisco TelePresence ISDN Link Administrator's Manual page 18

Cisco TelePresence ISDN Link
Contents Introduction
Making a call using the Touch
controller
If your telePresence endpoint has a touch controller see
the dialing example on this page.
About the ISDN number
• the ISDN number is the number to the far end
endpoint (for example an MXP codec).
Replace the number used in the example (8000) with
the number you want to call.
About restricted calls
If using the ISDN Restrict option, choose the Restrict in the
Call settings menu.
D14954.04 ISDN Link Administrator Guide IL1.1.2, MARCH 2015.
Getting started Getting started Software upgrade
1
2
18
Status information
How to make the call
touch the panel gently to wake up the system.
1. tap Dial or Contacts and enter the ISDN number you
want to call.
If the default call protocol is set to ISDN (H320),
proceed to Step 6, else proceed to Step 2.
2. tap the More (
3
3. tap Call rate button to open the ISDN call settings
menu.
4. Move the call protocol slider and choose ISDN.
5. Move the bandwidth slider to set the appropriate call
rate, or if dialing a telephone number, use the slider
to choose Audio Only.
6. tap the green Call button to make the call.
Connecting the call may take up to 30 seconds.
4
5
Administrator Guide
System settings Appendices
6
) button to open the call dialog.
•••
Copyright © 2015 Cisco Systems, Inc. All rights reserved.