Cisco TelePresence ISDN Link Administrator's Manual page 17

Cisco TelePresence ISDN Link
Contents Introduction
Configuring the TelePresence endpoint for ISDN
When paired to ISDN Link, the default call settings for the telePresence endpoint can be configured
for ISDN (H320), or you can set the call protocol and call rate each time you make a call.
Setting the default call protocol to H320
Configuring the default call settings to ISDN (H320):
1. open a web browser on your computer, enter the address (IP address or host name) of the
telePresence endpoint in the address bar, and login.
• Navigate to Configuration > System configuration > Conference 1 > DefaultCall and set the
Protocol to H320.
• Click the Save button.
Setting the call protocol to H320 by each call
• If using a telePresence touch device, see:
page 18.
• If using a telePresence Remote Control, see:
page 19.
• If calling from the telePresence endpoint's web interface, see:
interface of the endpoint" on page 20.
D14954.04 ISDN Link Administrator Guide IL1.1.2, MARCH 2015.
Getting started Getting started
"Making a call using the touch controller" on
"Making a call using the remote control" on
"Making a call using the web
Software upgrade Status information
17
Administrator Guide
System settings Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.