Cisco TelePresence ISDN Link Administrator's Manual page 15

Cisco TelePresence ISDN Link
Contents Introduction
Configuration examples
use the search option on the page to find the parameters, or
choose from the list of menus to the left and then navigate to the
parameters in the right pane.
Example with support for BRI Euro type
Set the net type:
H320 > General Settings > Nettype: BRI
Set the BRI switch type. the switch type setting must match the
switch type for the BRI network the ISDN Link is connected to.
ISDN > BRI > Switchtype: euro
enter the BRI numbers according to the assigned numbers for
each interface, replace xxx with your numbers::
ISDN > BRI Interface 1 > DirectoryNumber 1 Number: xxx
ISDN > BRI Interface 1 > DirectoryNumber 2 Number: xxx
ISDN > BRI Interface 2 > DirectoryNumber 1 Number: xxx
ISDN > BRI Interface 2 > DirectoryNumber 2 Number: xxx
ISDN > BRI Interface 3 > DirectoryNumber 1 Number: xxx
ISDN > BRI Interface 3 > DirectoryNumber 2 Number: xxx
ISDN > BRI Interface 4 > DirectoryNumber 1 Number: xxx
ISDN > BRI Interface 4 > DirectoryNumber 2 Number: xxx
enable the BRI interfaces in use:
ISDN > BRI Interface 1 > Mode: on
ISDN > BRI Interface 2 > Mode: on
ISDN > BRI Interface 3 > Mode: on
ISDN > BRI Interface 4 > Mode: on
Check the status after configuration
Go to Configuration > Peripherals and check the ISDN status
information to confirm there are no errors before proceeding. If any
errors, or if the power LeD is red, please check your configuration.
Note: Please refer to xConfiguration ISDN BRI AutoActivation if
connected to equipment enforcing BRI line deactivation when BRI
lines are not in use.
D14954.04 ISDN Link Administrator Guide IL1.1.2, MARCH 2015.
Getting started Getting started Software upgrade
15
Status information System settings
Navigate to H320 > General Settings >
Nettype.
Set the H320 Net type:
•
Click the Save button.
Navigate to ISDN > BRI > Switchtype.
Set the ISDN BRI Switch type:
•
Click the Save button.
Navigate to ISDN > BRI > Interface [1..4].
enter the BRI numbers according to the
assigned numbers for each interface,
replace xxx with your numbers::
•
enable the BRI interfaces in use:
•
Click the Save buttons.
Copyright © 2015 Cisco Systems, Inc. All rights reserved.
Administrator Guide
Appendices
BRI
euro
ISDN > BRI Interface [1..4] >
DirectoryNumber [1..2] Number: xxx
ISDN > BRI Interface [1..4] > Mode: on