Cisco TelePresence ISDN Link Administrator's Manual page 67

Cisco TelePresence ISDN Link
Contents Introduction
SIP Profile [1..1] Type
Note: only applicable when used in manual pairing mode.
enables SIP extensions and special behaviour for a vendor or provider.
<Standard/Alcatel/Avaya/Cisco/Microsoft/Nortel/Broadsoft>
Value space:
Standard: to be used when registering to standard SIP Proxy (tested with Cisco
telePresence VCS and Broadsoft)
Alcatel: to be used when registering to Alcatel-Lucent omniPCX enterprise. Note: this
mode is not fully supported.
Avaya: to be used when registering to Avaya Communication Manager. Note: this mode is
not fully supported.
Cisco: to be used when registering to Cisco unified Communication Manager.
Microsoft: to be used when registering to Microsoft LCS or oCS. Note: this mode is not
fully supported.
Nortel: to be used when registering to Nortel MCS 5100 or MCS 5200 PBX. Note: this
mode is not fully supported.
Broadsoft: to be used when registering to Broadsoft.
SIP Profile [1..1] URI 1
Note: only applicable when used in manual pairing mode.
the SIP uRI or number is used to address the system. this is the uRI that is registered and
used by the SIP services to route inbound calls to the system. A uniform Resource Identifier
(uRI) is a compact string of characters used to identify or name a resource.
<S: 0, 255>
Value space:
Format: Compact string with a maximum of 255 characters.
SIP Profile [1..1] Authentication [1..1] LoginName
Note: only applicable when used in manual pairing mode.
this is the user name part of the credentials used to authenticate towards the SIP proxy.
<S: 0, 128>
Value space:
Format: String with a maximum of 128 characters.
D14954.04 ISDN Link Administrator Guide IL1.1.2, MARCH 2015.
Getting started Software upgrade
SIP Profile [1..1] Authentication [1..1] Password
SIP Profile [1..1] Proxy [1..4] Address
SIP Profile [1..1] Proxy [1..4] Discovery
67
Status information
Note: only applicable when used in manual pairing mode.
this is the password part of the credentials used to authenticate towards the SIP proxy.
<S: 0, 128>
Value space:
Format: String with a maximum of 128 characters.
Note: only applicable when used in manual pairing mode.
the Proxy Address is the manually configured address for the outbound proxy. It is possible to
use a fully qualified domain name, or an IP address. the default port is 5060 for tCP and uDP
but another one can be provided. If outbound is enabled, multiple proxies can be addressed.
<S: 0, 255>
Value space:
Format: Compact string with a maximum of 255 characters. An IP address that contains
letters (192.a.2.0) or unvalid IP addresses (192.0.1234.0) will be rejected.
Note: only applicable when used in manual pairing mode.
Select if the SIP Proxy address is to be obtained manually or by using Dynamic Host
Configuration Protocol (DHCP).
<Auto/Manual>
Value space:
Auto: When Auto is selected, the SIP Proxy address is obtained using Dynamic Host
Configuration Protocol (DHCP).
Manual: When Manual is selected, the manually configured SIP Proxy address will be used.
Administrator Guide
System settings System settings Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.