Cisco TelePresence ISDN Link Administrator's Manual page 54

Cisco TelePresence ISDN Link
Contents Introduction
Gateway configuration
Gateway PairingMode
Configure the ISDN Link to operate in automatic or manual pairing mode. Pairing is a process
in which the ISDN Link and endpoint communicate with each other in order to establish a
connection. When pairing is completed the ISDN Link is dedicated to the endpoint it has been
paired with. the automatic pairing mode provides an improved user experience, but requires
that the endpoint supports this feature.
<Auto/Manual>
Value space:
Auto: Set to Auto (default) to enable the ISDN Link to be discovered by a telePresence
endpoint. In automatic pairing mode the ISDN Link can be managed from the telePresence
endpoint's web interface.
Manual: In manual pairing mode the ISDN Link is managed from a command line interface
through the serial interface, or over the network through SSH.
Gateway SIP PeerHost
Note: only applicable when in manual pairing mode.
Set the IP address of the peer SIP codec using the ISDN link. only one SIP codec can use the
ISDN link, and it must be on the same subnet as the ISDN link. this IP address must correspond
to the IP address type (IPv4 or IPv6) that the codec is configured to use for SIP calls.
the address is used for:
1) Verification of the SIP remote media transport addresses (if there is a mismatch, the call will
be rejected/disconnected).
2) System status monitoring, indicating alarm etc if specified codec is not reachable.
3) If not SIP registered, this address is used to call the SIP codec for incoming H.320 side calls.
<S: 0, 64>
Value space:
Format: Compact string with a maximum of 64 characters.
D14954.04 ISDN Link Administrator Guide IL1.1.2, MARCH 2015.
Getting started Software upgrade
Gateway SIP PeerUri
54
Status information
Note: only applicable when in manual pairing mode.
Set the address be used to reach the peer codec for incoming H.320 side calls when SIP
registered mode is used. It should hold the same setting as the peer codec uses to register
itself. If SIP registered mode is not used, this setting is not used.
<S: 0, 256>
Value space:
Format: Compact string with a maximum of 256 characters.
Administrator Guide
System settings System settings Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.