Cisco TelePresence ISDN Link Administrator's Manual page 56

Cisco TelePresence ISDN Link
Contents Introduction
ISDN configuration
ISDN CliNumbPlan
Value to be used for calling party number field Plan in the ISDN setup message. If the value is
set to 1, the numbering plan in the setup message will signal ISDN. this is required in the uAe
(united Arab emirates).
<0..14>
Value space:
Range: Select a value between 0 and 14.
ISDN CliNumbSpec
Select if calling party numbers should be enabled. explicitely specify Calling Party Number
fields type/Plan to be used in outgoing calls in the ISDN setup message.
<Off/On>
Value space:
Off: When set to off, default values are used.
On: When set to on, the system will use the values set by "ISDN CliNumPlan" and "ISDN
CliNumbtype".
ISDN CliNumbType
Value to be used for calling party number field type. If the value is set to 2, the number type in
the setup message will be set to National. this is required in the uAe (united Arab emirates).
<0..6>
Value space:
Range: Select a value between 0 and 6.
ISDN HLC
Select if HLC (Higher Level Capability) information should be included in the setup message
(video calls only).
<Off/On>
Value space:
Off: When set to off, no HLC information will be sent.
On: When set to on, the system will signal the type of call i.e. video call, telephony or data.
HLC must be enabled to work with some PRI networks in Italy.
D14954.04 ISDN Link Administrator Guide IL1.1.2, MARCH 2015.
Getting started Software upgrade
ISDN MSN
ISDN ParallelDial
ISDN SendComplete
ISDN SendNumber
56
Status information
the use of MSN (Multiple Subscriber Number) enables the system to attach different ISDN
terminals, with different numbers, to the same physical ISDN telephone line. this service can be
ordered from your telephone company.
<Off/On>
Value space:
Off: When set to off, only calls to numbers specified for the specific ISDN interfaces will be
answered.
On: Set to on to enable MSN on the video system when you have subscribed to a MSN
service from your telephone company.
Select if the channels in bonding calls should be connected in parallel or one by one.
<Off/On>
Value space:
Off: When set to off, channels will be dialled one by one, which may increase the dialling
time.
On: When set to on, channels will be dialled and connected in parallel when setting up a
bonding call.
Select if the ISDN message should contain sending complete information.
<Off/On>
Value space:
Off: If set to off the system will not send Sending Complete.
On: If set to on the system will send the ISDN message information element Sending
Complete.
Select if the system should send its own number to the far end.
<Off/On>
Value space:
Off: When set to off, the system will not send its own numbers to the far end. Note that the
network may still send your numbers to the far end.
On: When set to on, the system will send its own numbers to the far end.
Administrator Guide
System settings System settings Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.