Cisco TelePresence ISDN Link Administrator's Manual page 46

Cisco TelePresence ISDN Link
Contents Introduction
xStatus SystemUnit State H320Number
Shows the number that can be used to dial in on the ISDN BRI/PRI interface in order to reach
this ISDN Link and subsequently the endpoint associated with the ISDN Link. this requires that
numbers have been assigned to the BRI or PRI interfaces respectively.
Not applicable when using the external network (Net) interface.
Format: String.
xStatus SystemUnit State MaxNumberOfCalls
Shows the maximum number of simultaneous calls supported, with the current configuration.
the normal value is 3, with the following exceptions:
1) When using the external (V.35) interface, only one call is possible.
2) When H.320 side encryption is enabled, maximum 2 calls are supported on the PRI
interface.
Format: Integer between 1 and 3.
xStatus SystemUnit State NumberOfActiveCalls
Shows the number of active calls.
Format: Integer between 0 and 3.
xStatus SystemUnit State NumberOfSuspendedCalls
Shows the number of suspended calls.
Format: Integer between 0 and 3.
xStatus SystemUnit State NumberOfInProgressCalls
Shows the number of calls in progress.
Format: Integer between 0 and 3.
D14954.04 ISDN Link Administrator Guide IL1.1.2, MARCH 2015.
Getting started Software upgrade
46
Status information Status information System settings
Copyright © 2015 Cisco Systems, Inc. All rights reserved.
Administrator Guide
Appendices