Cisco TelePresence ISDN Link Administrator's Manual page 13

Cisco TelePresence ISDN Link
Contents Introduction
Configuration examples
use the search option on the page to find the parameters, or
choose from the list of menus to the left and then navigate to the
parameters in the right pane.
Example with support for PRI E1 mode
Set the H320 net type to PRI:
H320 > General Settings > Nettype: PRI
Set the PRI switch type to e1 (euro):
ISDN > PRI > Switchtype: euro
Set the number of the high channel for PRI e1 mode:
ISDN > PRI Interface 1 > HighChannel: 31
Set the number of PRI channels:
ISDN > PRI Interface 1 > MaxChannels: 30
enter the PRI number(s), replace xxx with your number(s):
ISDN > PRI Interface 1 > NumberRangeStart: xxx
ISDN > PRI Interface 1 > NumberRangeStop: xxx
Check the status after configuration
Go to Configuration > Peripherals and check the ISDN status
information to confirm there are no errors before proceeding. If any
errors, or if the power LeD is red, please check your configuration.
D14954.04 ISDN Link Administrator Guide IL1.1.2, MARCH 2015.
Getting started Getting started Software upgrade
13
Status information System settings
Navigate to H320 > General Settings >
Nettype.
Set the H320 Net type:
•
Click the Save button.
Navigate to ISDN > PRI > Switchtype.
Set the ISDN PRI Switch type:
• euro
Click the Save button.
Navigate to ISDN > PRI > Interface 1.
enter the number of high and maximum
channels for the PRI euro switch:
• HighChannel: 31
• MaxChannels: 30
enter your ISDN PRI number:
• NumberRangeStart: xxx
• NumberRangeStop: xxx
Click the Save buttons.
Copyright © 2015 Cisco Systems, Inc. All rights reserved.
Administrator Guide
Appendices
PRI