Cisco TelePresence ISDN Link Administrator's Manual page 19

Cisco TelePresence ISDN Link
Contents Introduction
Making a call using the remote
control
If your telePresence endpoint has a remote control, see
the dialing example on this page.
About the ISDN number
• the ISDN number is the number to the far end
endpoint (for example an MXP codec).
Replace the number used in the example (8000) with
the number you want to call.
About restricted calls
If using the Restrict option, choose the ISDN Restrict in the
Call settings menu.
D14954.04 ISDN Link Administrator Guide IL1.1.2, MARCH 2015.
Getting started Getting started Software upgrade
How to make the call
Press any button on the remote control to wake up the
system.
1. Press (home) button to open the Home menu.
2. Press (right arrow) to open the Call menu.
3. use the numeric pad and enter the ISDN number you
want to call.
If the default call protocol is set to ISDN (H320), proceed
to Step 6, else proceed to Step 4.
4
5
4. Press the fifth soft button to display the Call Type menu.
use the arrow keys to navigate and choose ISDN.
(ok)
Press to confirm your selection.
5. Press the fourth soft button to display the Call Rate menu.
use the arrow keys to navigate and choose the call rate. If
dialing a telephone number, choose Audio Only.
Press (ok) to confirm your selection.
19
Status information System settings
1
(home)
(ok)
(ok)
Copyright © 2015 Cisco Systems, Inc. All rights reserved.
Administrator Guide
Appendices
2
(right arrow)
3
6. Press (call) to connect the
call. Connecting the call may
take a few seconds. A message
will show on screen while the
call is connecting.
Connecting the call may take up
to 30 seconds.
6
(call)