Point-To-Point Configuration - CyberData 011146 Operation Manual

2.6.7.1 Point-to-Point Configuration

It is possible to use the device as a paging endpoint without registering it with a SIP server by
configuring it for Point-to-Point paging. To do this, complete the following steps:
1. On the SIP page
2. Click on the Save button to save the changes.
3. Click on the Reboot button to reboot the device.
4. Enter the device's IP address as a "speed dial" (also called "auto-dial") key on the phone(s) from
Note
Register with a SIP Server is not selected
CyberData Corporation
(Figure
• The Register with a SIP Server parameter is not selected.
• The Enable SIP Operation parameter is selected
which you want to page.
Establishing point-to-point SIP calls may not work with all phones.
Figure 2-16. SIP Page
CyberData Paging Server
2-16), make sure of the following:
Enable SIP Operation is selected
931803A
Setting Up the SIP Paging Server
Configure the SIP Parameters
Operations Guide
35