Point-To-Point Configuration - CyberData 011146 Operation Manual

2.4.7.1 Point-to-Point Configuration

When the board is set to not register with a SIP server, it's possible to set the device to dial out to a
single endpoint. To do this, do the following:
1. On the SIP page
2. Type the IP address of the remote device that you want to contact into the Dial out Extension
Note
CyberData Corporation
(Figure 2-17), make sure that the Register with a SIP Server parameter is not
selected.
field
Establishing point-to-point SIP calls may not work with all phones.
Figure 2-17. SIP Page Set to Point-to-Point Mode
Device is set to NOT register with a SIP server
931073B
Setting Up the Paging Server
Configure the SIP Parameters
Operations Guide
37